Actuate Standing Lights And Parking Lights, Basic Function - GF82.10-P-1000A
Model all (4xWD)
Model all (CAR)
Overview
This document contains the following information:
- General
- Function
- Actuate standing and parking lights
- Lights on warning
General
The activated standing/parking lights make the contours of the vehicle visible in darkness or conditions of poor visibility.
The standing/parking lights are operated via the exterior lighting switch.
The standing/parking lights are switched off at circuit 15 OFF depending on the energy status of the on-board electrical system battery.
Function
Actuate standing and parking lights
The exterior lighting control unit actuates the standing/parking lights in the lamp units at front and, where applicable, at rear on the vehicle independently or it requests actuation. This takes place depending on the version of the front lamp units (halogen headlamps or LED headlamps) and depending on the vehicle's network architecture. The exterior lighting control unit is the central controller unit or the front central controller unit, depending on the vehicle equipment involved.
When the standing lights are switched on, the license plate lamps are also switched on. The switched on standing/parking lights are displayed in the instrument cluster.
The standing lights can also be switched on due to the low beams or daytime running lights (Japan version). When opening the driver's door (vehicle parked) the standing lights are switched off.
On vehicles equipped with a trailer hitch, the exterior lighting control unit requests actuation of the standing/parking lights on the trailer. The trailer recognition control unit implements this request.
If the surround lighting function is activated, this is then automatically switched on in darkness after switching off the engine.
The standing lights remain on for the time configured in the system from the point at which the last door or the trunk lid or the liftgate was closed.
Lights on warning
If the vehicle is exited and the standing lights are still switched on (exterior lights switch in standing lights position), a message is shown on the instrument cluster. An acoustic warning also sounds.
| Function schematics | |||
|---|---|---|---|
| Function schematic, actuate standing/parking lights | Model 118, 177, 243, 247 | PE82.10-P-2503-97A | |
| Model 167Model 293 | PE82.10-P-2503-97B | ||
| Model 213, 238, 257, 290 as of model year 2021 | PE82.10-P-2503-97D | ||
| Model 206, 223, 232, 254, 295, 296, 297 | PE82.10-P-2503-97E | ||
| Model 464 | PE82.10-P-2503-97F | ||
| Further basic functions | |||
| Trailer recognition control unit, basic function | Model all (CAR) with code 550 (Trailer coupling) |
GF31.19-P-9890A | |
| Basic function of signal acquisition and actuation module | Model 118, 177, 243, 247, 464 | GF54.21-P-9895A | |
| Basic function of signal acquisition and actuation module at front | Model 167, 206, 223, 232, 254, 293, 295, 296, 297 | GF54.21-P-9896A | |
| Model 213, 238, 257, 290 as of model year 2021 | |||
| Headlamp control unit, basic function | Model all (CAR) | GF82.10-P-9890A | |
| Front lamp unit, basic function | GF82.10-P-2000A | ||
| Rear lamp unit, basic function | GF82.10-P-2004A | ||
| License plate lamp, basic function | GF82.10-P-2015A | ||
| Exterior lights switch, basic function | GF82.10-P-2022A | ||