Remove/install HERMES control unit - AR82.95-P-0019NKC
MODEL 117.3 with CODE 360 (HERMES UMTS)
MODEL 117.3 with CODE 362 (HERMES LTE)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform initial startup of HERMES control unit (N112/9) | When replacing the HERMES control unit (N112/9). | |
| AD00.00-P-2000-04A | |||
| 2 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Remove C-pillar trim at left | AR68.30-P-4490NKC | |
| 4 | Loosen rear shelf until HERMES control unit (N112/9) is accessible | AR68.30-P-4581NKC | |
| 5 | Unscrew nuts (2) | ||
| 6 | Remove HERMES control unit (N112/9) and position it in a way that allows for the electrical connectors (3) to be disconnected | ||
| 7 | Detach electrical connections (3) | ||
| 8 | Install in the reverse order |