Remove/install door frame seal on rear door - AR72.12-P-1015NKC

MODEL 117 

Fig 1: Door Frame Seal On Rear Door Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Door Frame Seal On Rear Door Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Open rear door
2	Unclip sealing rail shaped part (3) and front sealing rail shaped part (4) from inner door panel (2) until door frame seal (1) can be removed
3	Remove door frame seal (1) from inner door panel (2)
4	Remove adhesive residues from inner door panel (2) with stripe off wheel and clean bonding surface.
	Notes on removing adhesive residues and foils on paint and metal surfaces with surface conditioning disks		AH00.00-P-0013-01AK
		Stripe off wheel, Ø 100 mm, with mounting shaft, 3M Deutschland GmbH D-41453 Neuss The bonding surface must be free of dust and grease.
		Cleaner	*BR00.45-Z-1025-04A
	Install
5	Shorten door frame seal (1)	To shorten, lay old door frame seal and on top of new door frame seal (1). Start cutting new door frame seal (1) at end opposite  joining element.
6	Loosen spacer strips (6) approx. 2 cm at one end of the new door frame seal (1)	This facilitates removal of the spacer strips (6) after gluing on the door frame seal (1)
7	Detach protective foil (5) approx. 5 cm	Detach protective foil (5) on side of door sealing frame (1), glued to side of inner door panel (2) to which door lock is fastened.
8	Glue door frame seal (1) to inner door panel (2), then detach protective foil (5) in increments and glue door frame seal (1) up to end of inner door panel (2)	Start at side of inner door panel (2) where door lock is located. Mark inner door panel (2) as orientation aid (arrows). The spacer strips (6) on the door frame seal (1) should make contact without gaps over the entire length of the inner door panel (2)
9	Roll on door frame seal (1) with roller	Roller	Figure
10	Completely remove spacer strips (6) from door frame seal (1) starting at detached end
11	Clip rear sealing rail shaped part (3) and front sealing rail shaped part (4) into inner door panel (2)	Ensure that rear sealing rail shaped part (3) and front sealing rail shaped part (4) are seated correctly in inner door panel (2). Ensure that end pieces of door frame seal (1) are seated correctly in the corresponding rear sealing rail shaped part (3) and front sealing rail shaped part (4).
12	Close rear door

Fig 3: Roller (168 589 05 63 00)

Courtesy of MERCEDES-BENZ USA

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1025-04A	Cleaner	A 005 989 19 71