Remove/install bulbs of headlamp unit - AR82.10-P-1201NKM

MODEL 117 as of model year 2016 with CODE 613 (Headlamps for RHD vehicles) except CODE 614 (Bi-xenon headlamps) except CODE 615 (Bi-xenon headlamps with active light function) except CODE 618 (Bi-xenon headlamps) except CODE 621 (Intelligent Light System (left-hand traffic)) except CODE 622 (Intelligent Light System)

MODEL 117 as of model year 2016 with CODE 620 (Halogen headlamps) except CODE 614 (Bi-xenon headlamps) except CODE 615 (Bi-xenon headlamps with active light function) except CODE 618 (Bi-xenon headlamps) except CODE 621 (Intelligent Light System (left-hand traffic)) except CODE 622 (Intelligent Light System)

Shown on left front headlamp in model 117

Fig 1: Headlamp Unit Bulb Remove/Install Components - Shown On Left Front Headlamp In Model 117

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off exterior lights
2	Switch on ignition and store transmitter key outside of transmission range (min. 2 m)
3	Turn wheel until service flap is accessible in left or right front axle fender liner	When removing low beam bulb (5).
4	Open service flap in front axle fender liner, left and/or right	When removing low beam bulb (5).
5	Remove low beam covering cap (1)	When removing low beam bulb (5).
6	Disconnect electrical connection from low beam bulb (5)	When removing low beam bulb (5).
7	Release and remove low beam bulb (5) by turning it in a counterclockwise direction	When removing low beam bulb (5).
7		Do not touch the low beam bulb (5) with bare fingers. Otherwise, the bulb will be damaged by overheating when in operation.
8	Remove covering cap for high beam and standing light (3)	When removing the high beam and standing light bulb (4). The covering cap for the high beam and standing light (3) can be accessed through the engine compartment.
9	Release and remove high beam and standing light bulb (4) by turning it in a counterclockwise direction	When removing the high beam and standing light bulb (4). Do not touch the high beam and standing light bulb (4) with bare fingers. Otherwise, the bulb will be damaged by overheating when in operation.
10	Release and remove socket for corner-illuminating fog lamp (2) by turning in counterclockwise direction	When removing corner-illuminating fog lamp. The socket for the corner-illuminating fog lamp (2) is accessible through the engine compartment.
11	Remove corner-illuminating fog lamp from socket for corner-illuminating fog lamp (2) by turning it	When replacing corner-illuminating fog lamp. Do not touch glass bulb of corner-illuminating fog lamp with bare fingers. Otherwise, the bulb will be damaged by overheating when in operation.
12	Install in the reverse order
	Check
13	Check headlamp adjustment, adjust if necessary
			AP82.10-P-8260GI