Make Cutout For Universal Holder On Seat Backrest Padding - AR91.10-P-1120-01LWE

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 205.0/1/2, 213, 253, 293

with code 866 (Pre-installation for Rear Seat Entertainment System)

Courtesy of MERCEDES-BENZ USA

Print out template (1).
Determine and take note of dimensions (a, b) of printed template (1).
Copy printed template (1) with corresponding factor to original size.
Original size:

Dimension (a) = 200 mm

Dimension (b) = 160 mm

To determine the factor, divide the dimension (a, b) of the original size by the corresponding calculated dimension (a, b).

Courtesy of MERCEDES-BENZ USA
Cut out the template copied to the original size (1).
Position the template (1) on the padding (2).
The notches (1.1) must lie over the notches (arrows).
Draw notch of template (1) onto padding (2).
Remove template (1).
Produce cutout on padding (2) using marking and the old part.
Align the tip of the blade with the cutting line of the old part.

Otherwise, the padding (2) may be damaged.