Remove/Install CROSSMEMBER Under Instrument Panel - Ar62.30-P-1250LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205
Model 253
Model 293
Shown on model 205.0
Shown on model 205.0
| Remove/install | |||
| 1 | Remove dashboard | Model 205 Model 253 Model 293 |
|
| Model 205 Model 253 |
AR68.10-P-1000LW . | ||
| 2 | Disconnect electrical connector of air outlet temperature sensor of side air vent from air duct LH (2) and air duct RH (3) | ||
| 3 | Remove left air duct (2) and right air duct (3) | ||
| 4 | Detach center air duct (4) from retaining clip (5) and remove in downward direction (arrows A) | Fig 1. | |
| 5 | Remove electrical wiring harness from crossmember (1) | ||
| Fig 2. | |||
| 6 | Remove screws (8a, 8b, 8c, 8d) from crossmember (1) and carefully set down steering column tube (6) | ||
| Topical note | Notes on threaded connections with aluminum screws/bolts | AH00.00-P-0006-01RM . | |
| Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | Position bolts (8a, 8b, 8c, 8d) lightly by hand first and then tighten them in the give sequence. |
AH00.00-P-0020-01A . |
| *BA46.10-P-1001-03S . | |||
| 7 | Remove center aid ducts (11) | ||
| 8 | Mark installation position of crossmember (1) in relation to A-pillars (arrows) | ||
| 9 | Remove windshield wiper system | Model 253 Model 293 |
|
| Model 253, 293 | AR82.30-P-6400LW . | ||
| 10 | Remove screw/bolts (12) | Model 293 Only one screw (12) is installed. |
|
| *BA68.10-P-1002-02F . | |||
| 11 | Remove bolts (13) | ||
| 12 | Unscrew screw (15) | *BA68.10-P-1004-02F . | |
| 13 | Remove bolts (14) | ||
| *BA68.10-P-1001-02F . | |||
| 14 | Remove crossmember (1) from vehicle on driver side | ||
| 15 | Install in the reverse order |
JACKET TUBE TORQUE SPECIFICATIONS
| Number | Designation | Model 205 | Model 253 | ||
|---|---|---|---|---|---|
| BA46.10-P-1001-03S | Bolt, steering column tube to crossmember under instrument panel | Stage 1 | Nm | 12 | 12 |
| Stage 2 | ∠° | 90 | 90 | ||
JACKET TUBE TORQUE SPECIFICATIONS
| Number | Designation | Model 293 | ||
|---|---|---|---|---|
| BA46.10-P-1001-03S | Bolt, steering column tube to crossmember under instrument panel | Stage 1 | Nm | 12 |
| Stage 2 | ∠° | 90 | ||
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 205 | Model 253 | |
|---|---|---|---|---|
| BA68.10-P-1001-02F | Screw/bolt, crossmember to A-pillar | Nm | 25 | 25 |
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 293 | |
|---|---|---|---|
| BA68.10-P-1001-02F | Screw/bolt, crossmember to A-pillar | Nm | 25 |
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 205 | Model 253 | |
|---|---|---|---|---|
| BA68.10-P-1002-02F | Screw/bolt, crossmember to firewall below windshield | Nm | 25 | 25 |
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 293 | |
|---|---|---|---|
| BA68.10-P-1002-02F | Screw/bolt, crossmember to firewall below windshield | Nm | 25 |
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 205 | Model 253 | |
|---|---|---|---|---|
| BA68.10-P-1004-02F | Screw/bolt, crossmember strut to side of transmission tunnel | Nm | 30 | 30 |
CROSSMEMBER BELOW INSTRUMENT PANEL TORQUE SPECIFICATIONS
| Number | Designation | Model 293 | |
|---|---|---|---|
| BA68.10-P-1004-02F | Screw/bolt, crossmember strut to side of transmission tunnel | Nm | 30 |