Sanding And Polishing Of Scratch Resistant CLEARCOAT Paints - Ar98.00-P-0012A

Model 117, 118, 156, 164, 166, 167, 170 as of 8/1/03, 171, 172, 176, 177, 203.0##/2## 1# as of 4/1/04, 203.7 as of 9/1/03, 204, 205, 206, 207, 209.3 as of 4/1/04, 209.4 as of 7/1/04, 211.00/01/02/04/05/06/07/20/21/22/24/25/26 as of 9/1/03, 211.08/09/28/29 as of 8/1/04, 212, 213, 215 as of 8/1/02, 216, 217, 218, 219, 220.0/1 as of 9/1/03, 221, 222, 223, 230 as of 8/1/03, 231, 232, 238, 240, 242, 243, 245, 246, 247, 251, 253, 257, 290, 292, 293, 295, 297, 463 as of 8/1/04 

	Grind and polish
1	Wash vehicle.	Car Wash	*BR00.45-Z-1002-04A .
2	Grind damaged area in paint with fine-grained abrasive paper.	The grain size must be at least P2500. A better option would be a grain size between P3000 and P5000.
3	Place polishing sponge exactly in the center on the polishing pad.	Before commencing the first polishing operation, spray some deionized water lightly onto the polishing sponge.
4	Apply a little paintwork polish at the polishing area.	Shake paintwork polish well before use. Polish, silicone-free 5 l, DB supply specification 7545.00	*BR00.45-Z-1013-04A .
		Polish 500 ml	*BR00.45-Z-1036-04A .
		MB Nano polish	*BR00.45-Z-1062-04A .
5	Polish the surface to be treated for at least 10 s at the lowest machine speed, approx. 80C rpm (stage 1), applying moderate pressure in a cross-coat action over the damaged area.	Make uniform movements with the polishing machine and comply with the polishing time at a damaged area. Otherwise visible irregularities occur in the paint surface. On larger areas make sure that you always polish-out one partial area (approx. 1/4 m2) at a time. As the paintwork polish pulverizes during polishing, a more marked abrasive effect is visible initially. The high gloss is only produced at the end.
6	Polish the surface to be treated for a maximum of 30 s at increased machine speed, approx. 1300 rpm (3rd stage) to 1600 rpm (4th stage), applying moderate pressure in a cross-coat action over the damaged area.	Make uniform movements with the polishing machine and do not exceed the polishing time at a damaged area. Otherwise visible irregularities occur in the paint surface. On larger areas make sure that you always polish-out one partial area (approx. 1/4 m2 ) at a time. As the paintwork polish pulverizes during polishing, a more marked abrasive effect is visible initially. The high gloss is only produced at the end.
7	Spray on de-ionized water and remove polish residue using a tack rag.
8	Seal polished surface with gloss preservation.	Shake gloss preservation well before use. Gloss preservation, 500 ml, DB supply specification 7551.10	*BR00.45-Z-1014-04A .