Polish Damaged Areas - Ar98.00-P-0009SX

Model 117, 118, 156, 164, 166, 167, 170, 171, 172, 176, 177, 190, 197, 203, 204, 205, 206, 207, 209, 211, 212, 213, 215, 216, 217, 218, 219, 220, 221, 222, 223, 230, 231, 232, 238, 240, 242, 243, 246, 247, 251, 253, 257, 290, 292, 293, 295, 297, 463 

With more scratch-resistant clear-coat system 

	Polishing
1	Wash vehicle.	Car Wash	*BR00.45-Z-1002-04A .
2	Grind damaged area in paint with fine-grained abrasive paper.	The grain size must be at least P2500. A better option would be a grain size between P3000 and P5000.
3	Place polishing sponge exactly in the center on the polishing pad.	Before the first polishing operation, spray some deionized water onto the polishing sponge.
4	Apply a little paintwork polish at the polishing area.	Shake paintwork polish well before use. MB Nano polish	*BR00.45-Z-1062-04A .
5	Polish the surface to be treated for at least 10 s at the lowest machine speed, approx. 80C rpm (stage 1) using moderate pressure in a cross-coat action over the damaged area.	Make uniform movements with the polishing machine and comply with the polishing time at a damaged area. Otherwise visible irregularities occur in the paint surface. On larger areas make sure that you always polish-out one partial area (approx. 1/4 m2) at a time. As the paintwork polish pulverizes during polishing, a more marked abrasive effect is visible initially. The high gloss is only produced at the end. Do not exceed a polishing time of 30 s on any single rub-down area.
6	Spray on de-ionized water and remove polish residue using a tack rag.
7	Seal polished surface with gloss preservation.	Shake gloss preservation well before use. Gloss preservation, 500 ml, DB supply specification 7551.10	*BR00.45-Z-1014-04A .