Remove/Install Boot On Propeller Shaft Of Front Axle Gear - AR41.10-P-0070-01A
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 203.081/084/087/092/281/284/287/292, 210.08/28, 211.08/09/28/29, 220.083/084/087/183/184/187
Model 205 with transmission 722.96/97
Model 205, 213, 217, 218, 222, 223, 238, 253, 290 with transmission 725.0 with code M005 (Vehicles with 4MATIC/all-wheel drive)
Model 212, 217, 218, 222 with transmission 722.96/97
Model 253 with transmission 724.2
| Long-life grease (NLGI grade 2) | BB00.40-P-0266-02A |
Remove
- Pull universal joint (72) off propeller shaft (70).
- Remove dust boot (71).
Install
- Coat splined profile with long-life grease.
- Slide dust boot (71) with universal joint (72) onto drive shaft (70).
Pay attention to markings (arrows) for installation position.
- Check that dust boot (71) is seated correctly.