Remove Pilot Bushing - AR41.10-P-0250-02LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 213, 238, 253
Measure
- Measure and note dimension (a).
Depending on the flexible disk thickness, the specified press-in dimension may deviate when installing.
Remove
- Knock pilot bushing (10) using flat chisel uniformly onto drive shaft (arrow).
- 15 mm from the front edge of the pilot bushing (10), drill a hole (0 10 mm) at a right angle through the pilot bushing (10).
If pilot bushing (10) is seized.
- Insert suitable drift through hole and pry pilot bushing (10) out of drive shaft using two assembly levers.
If pilot bushing (10) is seized.