Press Rubber Mount With Grooved Ball Bearing Onto Linkage Arm - AR41.10-P-0100-05LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205, 213, 238, 253

Fig 1: Identifying Drift (126 589 03 15 00)

Courtesy of MERCEDES-BENZ USA

Press elastomer bearing with grooved ball bearing (7) onto joint fork of rear half of propeller shaft using drift (05).
The open side of the grooved ball bearing (7) must face downwards.

Courtesy of MERCEDES-BENZ USA