Press Deep-Groove Ball Bearing In/Out Of Elastomer Bearing Of Propeller Shaft - AR41.10-P-0100-02LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205, 253

Fig 1: Identifying Removal And Installation Tool (116 589 09 43 00)

Courtesy of MERCEDES-BENZ USA

Press out

Press out grooved ball bearing (8) out of elastomer bearing (7b) using press out/in tool (04a, 04b).

Courtesy of MERCEDES-BENZ USA

Press in
Press grooved ball bearing (8) into the rubberized bearing seat up to the contact surface (arrows) using press out/in tool (04a, 04b).
Ensure that the grooved ball bearing (8) is properly seated.

Courtesy of MERCEDES-BENZ USA