LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> C300 4Matic, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 353 (Interior Equipment - 253 Chassis) >> Testing & Repair >> Remove/Install Eyeglass Compartment On Roof - AR68.30-P-4400LWE

Remove/Install Eyeglass Compartment On Roof - AR68.30-P-4400LWE

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.0/1/2, 213, 253, 293 

G14187593Courtesy of MERCEDES-BENZ USA
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVING Remove     
1 Remove overhead control panel control unit (1).   AR82.20-P-1000LF
2 Open glasses compartment (2).    
3 Remove rubber mat from the glasses compartment (2).    
4 Press glasses compartment (2) in the direction of the damper (5) and unclip on the opposite side from the bearing.    
5 Unclip glasses compartment (2) at the side of the damper (5) from the bearing and remove.    
6 Unclip damper (5) and remove from housing (6).    
INSPECT Check     
7 Check gearwheel of the damper (5) and gearing on the glasses compartment (2) for damage and wear. If a problem arises:
↓
Replace corresponding component.
 
8 Check spring clips (3) for correct seat in glasses compartment (2). IMPORTANT Spring clips (3) must be fully seated on spindles of glasses compartment (2) If a problem arises:
↓
Correct position of relevant spring clip (3).
 
INSTALLING Install     
9 Insert glasses compartment (2) on the opposite side of the damper (5) in the bearing.    
10 Align glasses compartment (2) vertically. IMPORTANT Spring clips (3) must as shown be seated in front of retaining pins (4).  
11 Slightly bend glasses compartment (2) and insert into the bearing on the side of the damper (5).    
12 Insert rubber mat in the glasses compartment (2).    
13 Close glasses compartment (2).    
14 Insert damper (5) in housing (6) and clip in. IMPORTANT Do not insert damper (5) at an angle. Both engagements of damper (5) must engage almost simultaneously.  
15 Install overhead control panel control unit (1).   AR82.20-P-1000LF
INSPECT Check     
16 Check glasses compartment (2) for proper operation by opening and closing. IMPORTANT Perform test procedure at least three times.