Notes On Programming Garage Door Opener Transmitter Unit - AH68.05-P-0002-01A

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model all

with code 231 (Garage door opener)

Model all

with code 232 (Garage door opener)

Details on programming garage door opener transmitter unit as well as the corresponding compatibility list are given on the internet site:

http://www.eurohomelink.com

Programming in chapter "Current vehicles"

Programming the national version, learning in hand transmitter and synchronization of alternating code system is described in the Mercedes-Benz operating instructions.

Compatibility list in chapter "HomeLink compatibility".

Compatibility of garage door drive to garage door opener

If the garage door drive is not compatible with the garage door opener, a universal receiver (Fix Kit receiver) can be installed in the garage for modulating the radio signal.

Additional information on universal receivers is available at the internet address http://www.eurohomelink.com.

Misuse protection

As of model series 204 the garage door opener transmitter unit with misuse protection is installed. It is necessary to perform an initial startup procedure for this garage door opener transmitter unit when replacing using a diagnostic system. The safety code is initialized and the national version programmed.