Temperature-Controlled Cup Holder, Basic Function - GF68.00-P-9900A

Model 223 

with code 224 (Individual rear seats) 

Model all (CAR) 

with code 307 (Temperature-controlled cup holder in rear passenger compartment) 

Model all (CAR) 

with code 311 (Temperature-controlled cup holder) 

Overview 

This document contains information on:

• Cooling
• Heating up
• Fault messages

General 

Beverages can be cooled or heated with the temperature-controlled cup holder. It is possible to heat up to approx. 58°C and to cool down to approx. 3°C.

The main component parts of the temperature-controlled cup holder are:

• Residual heat indicator lamp (model-dependent)
• Cup holder button
• Cooling and heating element
• Fan
• Temperature sensor
• Electronic control

Function requirements 

• Circuit 15R ON

Cooling 

The user can activate or deactivate the cooling function via the cup holder push button switch. A blue indicator lamp displays the active cooling procedure.

The cooling procedure has the following time-dependent cooling output for a beverage can (volume: 0.33 l, temperature: 21°C):

• After 30 min: Approx. 15°C
• After 60 min: Approx. 10°C
• After 120 min: Approx. 5°C

Heating up 

The user can activate and deactivate the heating function via the cup holder push button switch. A red indicator lamp displays the active warming procedure.

The warming procedure has the following time-dependent warming output for a beverage can (volume: 0.33 l, temperature: 21°C):

• After 30 min: Approx. 30°C
• After 60 min: Approx. 40°C
• After 120 min: Approx. 50°C

As from a temperature of approx. 40°C, the residual heat indicator lamp signals the increased temperature (model-dependent).

Fault messages 

The indicator lamp displays errors that occur during operation by flashing correspondingly:

• Two flashes: The cup holder button is disabled.
• Three flashes: The cooling and heating element of the cup holder is impaired.
• Four flashes: The temperature sensor is impaired.