Remove/Install Underbody Paneling - Ar61.30-P-1001LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205

Model 253 With Engine 177, 264, 274, 276, 642, 651, 654, 656

Fig 1: Underbody Paneling Component Locations (Model 253 With Engine 177, 264, 274, 276, 642, 651, 654, 656) (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Shown on model 253 on left side of vehicle

Shown on model 205.4 with engine 274.9

Fig 2: Underbody Paneling Component Locations (Model 253 With Engine 177, 264, 274, 276, 642, 651, 654, 656) (2 Of 2)

Courtesy of MERCEDES-BENZ USA


	Notes on safety-relevant components		AH00.00-Z-0019-01A .
	Remove/install
1	Raise vehicle.		AR00.60-P-1002LWG .
2	Remove screws (9) and remove trim (10).	Model 253 with engine 177, 264, 274, 276, 642, 651, 654, 656
3	Remove screw/bolts (2).
4	Remove expansion rivet (5).	Model 205
5	Remove expansion rivets (3) and press front fender liner (4) to the side until the nut (6) underneath is accessible.	Model 205 A quick-release coupling is installed instead of the nut (6).
6	Remove nuts (6) and remove underfloor paneling (1).	Model 205 Partially quick-release couplings are installed instead of nuts (6). Model 205 Press on quick-release couplings to stop. Push underfloor paneling (1) below engine compartment paneling.
7	Remove nuts (7) and remove underfloor paneling (8).	The underfloor paneling (8) can deviate in position and mount depending on equipment installed.
8	Install in the reverse order.