LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> C300 4Matic, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 347 (Electrical System, Equipment & Instruments - 253 Chassis 5 Of 9) >> Testing & Repair >> Remove/Install Parktronic System (PTS) Control Unit - AR54.65-P-0006LW

Remove/Install Parktronic System (PTS) Control Unit - AR54.65-P-0006LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205 

up to model year 2019 

with code 235 (Active Parking Assist with PARKTRONIC) 

Model 253 (except 253.992/993) 

with code 235 (Active Parking Assist with PARKTRONIC) 

G14201376Courtesy of MERCEDES-BENZ USA
Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
REMOVINGINSTALLING Remove/install     
1 Commission parking system control unit (N62) When replacing parking system control unit (N62).  
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-04B
2 Remove right front seat. Model 205.0/1/2/3
up to model year 2019
with code 235 (Active Parking Assist with PARKTRONIC)
Model 253 (except 253.992/993)
with code 235 (Active Parking Assist with PARKTRONIC)
AR91.10-P-1000LW
    Model 205.4
up to model year 2019
with code 235 (Active Parking Assist with PARKTRONIC)
AR91.10-P-1000LWR
3.1 Remove right door sills. Model 205.0/1/2
up to model year 2019
with code 235 (Active Parking Assist with PARKTRONIC)
Model 253 (except 253.992/993)
with code 235 (Active Parking Assist with PARKTRONIC)
AR68.30-P-4100LW
3.2 Remove right door sill. Model 205.3/4
up to model year 2019
with code 235 (Active Parking Assist with PARKTRONIC)
AR68.30-P-4100CLW
4 Release rear right floor covering (1) and fold to one side.    
5 Release and disconnect electrical connectors (2).    
6 Unclip and remove parking system control unit (N62) from holders (arrows).    
7 Install in the reverse order.