Remove/Install Camera Cover Control Unit - AR54.21-P-0023LWX
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 253 with code 218 (Rear view camera)
Model 253 with code 501 (360° camera)
Shown on model 253.3 with code 218 (Reversing camera)
Fig 1: Camera Cover Control Unit Components Location - Model 253 With Code 218, 501 (Shown On Model 253.3 With Code 218)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | Model 253 with code 218 (Rear view camera) with code 871 (HANDS-FREE ACCESS) with code 889 (KEYLESS-GO) Model 253 with code 501 (360° camera) with code 871 (HANDS-FREE ACCESS) with code 889 (KEYLESS-GO) |
AH80.61-P-0001-01A | |
| Remove/install | |||
| 1 | Commission camera cover control unit (N42) | When replacing camera cover control unit (N42). | |
| AD00.00-P-2000-04B | |||
| 2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 3 | Remove luggage compartment trim on left | Model 253 (except 253.992/993) with code 218 (Rear view camera) with code 501 (360° camera) | AR68.30-P-1180LWG |
| Model 253.992/993 with code 218 (Rear view camera) with code 501 (360° camera) | AR68.30-P-1180RFW | ||
| 4 | Disconnect electrical connection (1) | ||
| 5 | Remove retaining clips (2) and remove camera cover control unit (N42) | ||
| 6 | Install in the reverse order |