Retrofit Holder For CA Module Card Reader - AZ82.60-P-0032-02LWG

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 253

except code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN))

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Use tape to mask off the area where the bracket for the CA module card reader is to be fastened to the load compartment well cover (3).
Mark hole location (arrow A).
Dimensions:

a = 350 mm

b = 120 mm
Mark hole location (arrow C).
Dimensions:

c = 10 mm

d = 10 mm

Courtesy of MERCEDES-BENZ USA
Place Velcro strip (4) at previously marked hole location (arrow A), align and mark remaining hole locations as indicated by the Velcro strip (4).
The Velcro strip (4) must be aligned at a right angle to the reference edge (arrow B).
Remove Velcro strip (4).
Drill holes of 6 mm ø at the marked hole locations.

Courtesy of MERCEDES-BENZ USA
Fasten Velcro strip (4) with the expansion rivets (5) to the load compartment well cover (3).
Use expansion rivets (5) with a Ø of 6 mm. The expansion rivets (5) are included in the scope of supply.

Courtesy of MERCEDES-BENZ USA
Drill 6 mm Ø hole at previously marked hole location (arrow C).
Make cuts (dashed lines) approx. 4 mm in length at four points at the drilled hole (arrow C).

Courtesy of MERCEDES-BENZ USA