Retrofit Electrical Wiring Harness For CA Module Card Reader - AZ82.60-P-0032-01LWH
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 253
with code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN))
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A |
- Connect blue 1-pin plug (2.1) to tuner unit (A90/4).
- Route wiring harness (2) to the installation location of the CA module card reader.
Note the extended length of the wiring harness (2) that connects to the CA module card reader.
The blue 1-pin plug (2.2) will be connected at a later stage to the CA module card reader.