Install Illuminated Door Sill - AZ82.20-P-0001-01LWG
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 253
Installation is shown on the example of the right-hand side of the vehicle. Installation at the left-hand side of the vehicle takes place in the same way.
- Clean contact surface of door sill in the hatched area.
- Remove carrier foil (8) from the right front illuminated door sill molding (E17/48).
Pay attention to guides (9) during subsequent installation.
- Position right front illuminated door sill molding (E17/48) on longitudinal member and press on evenly.
- Route right front illuminated door sill molding electrical line (12) above longitudinal member into cable duct.
- Connect black 2-pin connector (12.1) of right front illuminated door sill molding electrical line (12) to black 2-pin plug (2.6) of right front illuminated door sill molding branch-off line.
- Clip in created electrical connector at cable duct.
- Fix right front illuminated door sill molding electrical line (12) in place at body flange of longitudinal member and at longitudinal member using duct tape (10).