Remove/Install Front Axle Level Sensors - AR82.10-P-0004LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205
Model 213, 238
Model 253
Shown on model 205 except code M005 (4MATIC), left side of vehicle
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Remove/install | |||
| 1 | Remove left or right front wheel | AR40.10-P-1102A | |
| 2 | Release and detach corresponding plug (1) | ||
| 3 | Detach left or right front fender liner in front area and push toward front | Model 205, 253 | AR88.10-P-1300LW |
| Model 213, 238 | AR88.10-P-1300LWE | ||
| 4 | Unscrew nut (2) and unhook the linkage at left front level sensor (B22/8) or right front level sensor (B22/9) | ||
| 5 | Remove screws/bolts (3) and remove left front level sensor (B22/8) or right front level sensor (B22/9) | ||
| 6 | Install in the reverse order | ||
| Calibrate | |||
| 7 | Calibrate left front level sensor (B22/8) or right front level sensor (B22/9) using diagnostic system | When replacing left front level sensor (B22/8) or right front level sensor (B22/9). | |
| Model 238 | AD00.00-P-2000-06LWO | ||
| Model 205, 213, 253 | AD00.00-P-2000-04B | ||
| Check | |||
| 8 | Check headlamp adjustment and if necessary correct | When replacing left front level sensor (B22/8) or right front level sensor (B22/9). | |
| Model 205, 253 | AP82.10-P-8260E | ||
| Model 213, 238 | AP82.10-P-8260J |