Remove/Install Door Interior Actuating Mechanism On Rear Side Door - AR72.12-P-2310LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.0/1/2, 253

Courtesy of MERCEDES-BENZ USA

Shown on Model 205.014 on left door lining (1)

	Remove/install
1	Remove door lining (1).		AR72.12-P-1010LW
2.1	Drill plastic spot welds (3, 4) and remove inside door opener (2).	If the inside door opener (2) is attached using plastic spot welds (3, 4).
			AR72.00-P-0001-01LW
		Replace drilled plastic spot welds (3, 4) with screws. Attach the inside door opener (2) using screws from the repair kit. An appropriate washer for the screw must be placed on the plastic spot weld. (4).
2.2	Remove screws and take off the inside door opener (2).	If the inside door opener (2) is attached using screws.
3	Install in the reverse order