Remove/Install Rubber Mounts From Thrust Arm - AR35.20-P-0105-01LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205 (except 205.386/387/486/487)

Model 213 (except 213.088/089/288/289)

Model 253 (except 253.388/389/988/989)

Model 293

Notes on safety-relevant components

AH00.00-Z-0019-01A

Fig 1: Identifying Extraction And Insertion Tool (204 589 03 43 00)

Courtesy of MERCEDES-BENZ USA

Remove

Pull elastomer bearing (2) out of wheel carrier (3) using extraction and insertion tool (01).
Remove extraction and insertion tool (01) with elastomer bearing (2).

Courtesy of MERCEDES-BENZ USA

Install

Courtesy of MERCEDES-BENZ USA
Position extraction and insertion tool (01) with elastomer bearing (2) on wheel carrier (3).
Pull elastomer bearing (2) into wheel carrier (3) using extraction and insertion tool (01).
Pull in until the elastomer bearing (2) fully covers the cutout (a) in the extraction and insertion tool (01) (arrow).
Remove extraction and insertion tool (01).