Notes On Determining Headlamp Aiming Values - AH82.10-P-1005-01A
Model all (4xWD, CAR, Light transporter, smart)
The prescribed degree of inclination for main headlamps (1) is given in % specific to the vehicle.
The inclination dimension for front fog lamps is given in the respective manufacturer's specifications.
Other country-specific instructions must be observed accordingly.
Shown on Model 204.022 with 1.0 % inclination dimension for main headlamps
Shown on Model 934 with 1.25 % inclination dimension for main headlamps
Location of identification plate (2):
- Arox, Antos, Actros, Axor, Atego and Zetros, Unimog: On B-pillar on the front passenger side.
- Econic: Entrance on front passenger side.
- FGA (chassis for protected body, Model 437.46):
, See information from body manufacturer.
The headlamp adjuster is to be aligned between 10 cm and 30 cm in front of the headlamp, parallel to the front of the vehicle level with the light source.
Before checking the main headlamps and front fog lamps, the respective inclination dimension must be set on the headlamp aimer scale.
For headlamp adjusters with a cm scale, a specified inclination dimension of, for example, 1.25 % is equivalent to a set value of 12.5 cm on the scale.
For headlamp adjusters with a % scale, a specified inclination dimension of, for example, 1.25 % is also equivalent to a set value of 1.25 % on the scale.
All regulations and specifications in the operating instructions from the headlamp aimer manufacturer must be observed accordingly.