Complete Automatic Transmission - BA27.10-P-1000-04H
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Transmission 725.0/1
AUTOMATIC TRANSMISSION COMPLETE
| Number | Designation | Transmission 725.0/1 | |||
|---|---|---|---|---|---|
| BA27.10-P-1001-04H | Screw/bolt, transmission to engine | Nm | 39 | ||
| BA27.10-P-1002-04H | Screw/bolt, torque converter housing/adapter housing to transmission housing | M8 | Stage 1 | Nm | 10 |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1003-04H | Screw/bolt, external plate carrier to torque converter housing/adapter housing | M6 | Nm | 10 | |
| BA27.10-P-1004-04H | Screw/bolt, transmission housing to torque converter housing/adapter housing | M8 | Stage 1 | Nm | 10 |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1005-04H | Screw/bolt, firewall cover to transmission housing | M8 | Stage 1 | Nm | 10 |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1006-04H | Screw/bolt, firewall cover to external plate carrier | M6 | Nm | 10 | |
| BA27.10-P-1007-04H | Threaded fitting for oil line to torque converter housing | Nm | 40 | ||
| BA27.10-P-1008-04H | Screw/bolt, leaf spring for heat shield to transmission | Nm | 5 | ||
| BA27.10-P-1009-04H | Screw/bolt, heat shield to oil pan | Nm | 9 | ||
| BA27.10-P-1010-04H | Screw/bolt, oil pan to transmission housing | Stage 1 | Nm | 4 | |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1011-04H | Screw/bolt, rear bracket to transmission | Stage 1 | Nm | 10 | |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1012-04H | Collar nut, output flange to output shaft | Nm | 200 | ||
| BA27.10-P-1013-04H | Screw/bolt, oil guide pipe to transmission housing | Nm | 4 | ||
| BA27.10-P-1014-04H | Screw plug to transmission, rear | M16 | Nm | 22 | |
| M36 | Nm | 70 | |||
| BA27.10-P-1015-04H | Screw/bolt, park pawl actuator to transmission housing | Stage 1 | Nm | 4 | |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1016-04H | Screw/bolt, lift solenoid to park pawl actuator | Nm | 8 | ||
| BA27.10-P-1017-04H | Screw/bolt, interlock line contact carrier to torque converter housing | Nm | 8 | ||
| BA27.10-P-1018-04H | Screw/bolt, housing cover to torque converter housing | Nm | 8 | ||
| BA27.10-P-1019-04H | Screw/bolt, rotor position sensor to housing cover | Nm | 8 | ||
| BA27.10-P-1020-04H | Screw/bolt, rotor position sensor electrical connector to housing cover | Nm | 8 | ||
| BA27.10-P-1021-04H | Screw/bolt, valve block to torque converter housing | Nm | 8 | ||
| BA27.10-P-1022-04H | Screw, adapter housing to torque converter housing/drive unit housing | M6 | Nm | 8 | |
| M8 | Stage 1 | Nm | 10 | ||
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1023-04H | Screw/bolt, oil distributor bushing to housing cover | Nm | 8 | ||
| BA27.10-P-1024-04H | Bolt, ground line to transmission housing | Nm | 20 | ||
| BA27.10-P-1025-04H | Screw/bolt, thrust plate to adapter housing | Nm | 8 | ||
| BA27.10-P-1026-04H | Intermediate panel to housing cover | Nm | 8 | ||
| BA27.10-P-1027-04H | Bolt, intermediate housing to transmission housing | M8 | Stage 1 | Nm | 10 |
| Stage 2 | ∠° | 90 | |||
| M10 | Stage 1 | Nm | 30 | ||
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1028-04H | Bolt, adapter housing to intermediate housing | Nm | 47 | ||
| BA27.10-P-1029-04H | Screw, cable duct to transmission bell housing | Nm | 12 | ||
| BA27.10-P-1030-04H | Screw plug (thermostat element) to clutch housing | Nm | 10 | ||
| BA27.10-P-1031-04H | Bolt, oil cooler to transmission | M6 | Stage 1 | Nm | 5 |
| Stage 2 | Nm | 10 | |||
| BA27.10-P-1032-04H | Screw, oil cooler heat shield to transmission | Nm | 20 | ||
| BA27.10-P-1033-04H | Screw, heat shield to transmission | Nm | 8 | ||
| BA27.10-P-1034-04H | Screw, pilot bushing to rotor | M10 | Stage 1 | Nm | 55 |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1035-04H | Screw, electrical wiring harness holder to oil pan | Nm | 8 | ||
| BA27.10-P-1036-04H | Screw, electrical wiring harness holder to torque converter housing | Nm | 12 | ||
| BA27.10-P-1037-04H | Screw, holder for electric line to transmission | Nm | 20 | ||
| BA27.10-P-1038-04H | Screw, holder for rear engine mount to transmission housing | Stage 1 | Nm | 30 | |
| Stage 2 | ∠° | 90 | |||