Remove/Install Frontal Acceleration Sensor - AR91.60-P-0750LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 205

MODEL 213

MODEL 238

MODEL 253

MODEL 293

Fig 1: Left/Right Frontal Acceleration Sensor Components Location - Model 253 (Shown On Model 205.0)

Courtesy of MERCEDES-BENZ USA

Shown on model 205

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Disconnect ground line from on-board electrical system battery.	Model 293	AR54.10-P-0003EQ
		Model 238	AR54.10-P-0003LWO
		Model 205, 213, 253	AR54.10-P-0003LW
2.1	Loosen fender liner far enough to gain access to left frontal acceleration sensor (B48/1) or right frontal acceleration sensor (B48/2).	Model 205, 253, 293 Model 213 (except 213.088/089/288/289), 238 except code 489 (AIR BODY CONTROL) Model 213.088/089/288/289 Model 205, 253, 293	AR88.10-P-1300LW
		Model 213 (except 213.088/089/288/289), 238 except code 489 (AIR BODY CONTROL) Model 213.088/089/288/289	AR88.10-P-1300LWE
2.2	Remove center front engine compartment lining.	Model 213 (except 213.088/089/288/289), 238 with code 489 (AIR BODY CONTROL)
			AR61.20-P-1105LWE
3	Remove screw (2) and place coolant circulation pump (M13/5) to one side with lines connected.	Model 205, 213, 238, 253 Only when removing right frontal acceleration sensor (B48/2).
4	Separate electrical connector (4, 5).
5	Remove screw (1, 3) and remove left frontal acceleration sensor (B48/1) or right frontal acceleration sensor (B48/2).	Screw/bolt, frontal acceleration sensor to bumper crossmember	*BA91.60-P-1009-01O
6	Install in the reverse order
7	Check Supplemental Restraint System (SRS) using vehicle diagnosis system.
		Model 238	AD00.00-P-2000-06LWO
		Model 205 Model 213 Model 253	AD00.00-P-2000-04B

		Model 293	AD00.00-P-2000-06FR

AIRBAG

Number	Designation		Model 205.0/1/2/3	Model 205.4
BA91.60-P-1009-01O	Screw/bolt, frontal acceleration sensor to bumper crossmember	Nm	9	9

AIRBAG

Number	Designation		Model 213	Model 238
BA91.60-P-1009-01O	Screw/bolt, frontal acceleration sensor to bumper crossmember	Nm	9	8

AIRBAG

Number	Designation		Model 253	Model 293
BA91.60-P-1009-01O	Screw/bolt, frontal acceleration sensor to bumper crossmember	Nm	9	9