Remove/Install Front Door Control Unit - AR72.29-P-1001EQ
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 253, 293
Shown on driver door
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove door trim. | AR72.10-P-1000LW | |
| 2 | Release and disconnect electrical connectors (1) of driver's door control unit (N69/1) and/or front-passenger door control unit (N69/2). | ||
| 3 | Unclip and remove driver's door control unit (N69/1) and/or front-passenger door control unit (N69/2). | ||
| 4 | Install in the reverse order. | ||
| 5 | Perform commissioning of the driver's door control unit (N69/1) and front passenger door control unit (N69/2). | Only when replacing driver's door control unit (N69/1) and/or front-passenger door control unit (N69/2). | |
| Model 293 | AD00.00-P-2000-06FR | ||
| Model 253 | AD00.00-P-2000-04B |