Remove/Install AIR BODY CONTROL Plus Control Unit For More Accurate Control Of The Suspension - AR32.22-P-0003LWG
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 253
with code 489 (AIR BODY CONTROL)
Shown on model 253.9
Fig 1: AIR BODY CONTROL Plus Control Unit Components Location - Model 253 With Code 489 (Shown On Model 253.9)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | Model 253 with code 489 (AIR BODY CONTROL) with code 871 (HANDS-FREE ACCESS) with code 889 (KEYLESS-GO) |
AH80.61-P-0001-01A | |
| Remove/install | |||
| 1 | Perform initial startup of AIR BODY CONTROL Plus control unit (N51/8) | When replacing AIR BODY CONTROL Plus control unit (N51/8). | |
| AD00.00-P-2000-04B | |||
| 2 | Remove left side load compartment lining | Model 253 (except 253.992/993) with code 489 (AIR BODY CONTROL) |
AR68.30-P-1180LWG |
| Model 253.992/993 with code 489 (AIR BODY CONTROL) |
AR68.30-P-1180RFW | ||
| 3 | Remove nuts (1) and remove AIR BODY CONTROL Plus control unit (N51/8) from bracket | ||
| 4 | Disconnect electrical connections (2) and remove AIR BODY CONTROL Plus control unit (N51/8) | ||
| 5 | Install in the reverse order |