Spring Element, Basic Function - GF32.00-P-1000A

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model all (4xWD)

Model all (CAR)

Overview

This document contains information on:

General
Function

General

Through the suspension, unsprung masses (e.g. wheels, parts of the wheel suspension) are connected with sprung masses (e.g. drive, body). The steel suspension consists of coil springs. Coil springs offer a compact design in combination with the required shock absorbers.

There are two variants of coil spring.

Function

Coil springs with linear spring rate

Coil springs with linear spring rate have a constant diameter over the entire spring length. The spring force increases linearly with the load with which the spring is being compressed.

Coil springs with progressive spring rate

Coil springs with progressive spring rate have a diameter that changes over the entire spring length. This means that the spring force depends on the load. The spring steel wire that changes in diameter (inconstant spring steel wire) enables a softer, and so more comfortable, compression under light load. With increasing load, the larger wire diameter takes over cushioning and has a harder effect. Different spring rates are combined into one spring. This enables the combination of soft up to hard spring rates, depending on the load and the dynamic condition of the vehicle (braking, accelerating, cornering).