Remove/Install Pressure Transducer For Boost Pressure Control - AR07.17-P-7002MRA
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Engine 274.9 in model 205
Engine 274.9 in model 253
Shown on ENGINE 274.910 in MODEL 205.040
Fig 1: Pressure Transducer For Boost Pressure Control Components Location - Engine 274.9 In Model 253 (Shown On Engine 274.910 In Model 205.040)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| Remove/install | |||
| 1 | Remove upper engine cover | ||
| 2 | Remove engine air intake duct upstream of air filter | ||
| 3 | Mark vacuum hoses (3) to the respective connection | ||
| 4 | Detach vacuum hoses (3) from boost pressure control pressure transducer (Y77/1) | ||
| 5 | Release and disconnect electrical connection (1) | ||
| 6 | Remove screws/bolts (2) and take off boost pressure control pressure transducer (Y77/1) | *BA00.10-P-1002-04A | |
| 7 | Install in the reverse order | ||
| 8 |
Read out and erase fault memory | AD00.00-P-2000-04B |
METRIC SCREWS/BOLTS AND NUTS AS PER MBN 10 105, 10 143
| Number | Designation | 8.8 | 10.9 | |
|---|---|---|---|---|
| BA00.10-P-1002-04A | M6X1 | Nm | 9 | 13 |