Notes On Sealant Path For Front Cover To Cylinder Head XXX - AH01.30-P-1000-02MR
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Engine 133
Engine 260
Engine 264
Engine 270
Engine 274
MODIFICATION NOTES
| 02.06.2017 | The specified thickness of the sealant bead was increased to 2.0 mm (±0.5 mm). |
The sealing surfaces must be cleaned.
The sealing surfaces must be flat (replace any bent component parts).
The line (1) identifies the sealant path.
Use only the sealant listed in the repair products.
Apply the sealant at the specified sealant path in the form of a bead with a height and breadth of 2 0 mm (±0 5 mm).
The sealant bead must be continuous with no interruptions.
Do not spread the sealant bead.
Maximum assembly time: 10 minutes.
Once the parts have been assembled do not disassemble them again.
Shown on engine 264
Shown on ENGINE 270