Remove/Install Wind Deflector Net - AR77.25-P-1004LWR
Model 205.4
With Code 288 (Draft Stop For Convertible)
Model 217.4
Model 238.4
With Code 288 (Draft Stop For Convertible)
Shown on left side of vehicle
Fig 1: Wind Deflector Net Components Location - Model 205.4 With Code 288 (Shown On Left Side Of Vehicle)
| Remove/Install | |||
| 1 | Switch on ignition | The ignition must remain switched on during the entire repair procedure. |
|
| 2 | Move out wind deflector (1) with soft top closed | The wind deflector (1) is moved to the service position. |
|
| 3 | Unhook tab (3) on both sides | ||
| 4 | Remove adhesive strip from cover (4) | If installed. |
|
| 5 | Unclip cover (4) on left side | ||
| 6 | Unclip lower net weatherstrip (5) on left side (arrow A) | ||
| 7 | Uniformly pull net (2) out together of lower net weatherstrip (5) and upper net weatherstrip (6) to left (arrows B) | The left and right tab (3) must point toward rear. |
|
| Clean | |||
| 8 | Clean guides for lower net weatherstrip (5) and upper net weather strip (6) | ||
| 9 | Install in the reverse order |