Remove/Install Trunk Floor Front Section - AR68.80-P-0005LWW
Model 205.0 (except 205.013/047/053/054), 205.1 (except 205.147), 205.3, 213.0 (except 213.016/050/053/054), 213.1 (except 213.153/155)
Shown on model 205.0
Shown on model 205.0 with code 287 (Folding seat backrests in rear)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove retaining clips (2) and trunk floor (1). | Fig 2 | |
| 2 | Remove trim (10). | ||
| 3.1 | Remove tie-down eyes (7). | Model 205.0 (except 205.013/047/053/054), 205.3, 213.0 (except 213.016/050/053/054) with code 287 (Folding seat backrests in rear passenger compartment) Model 205.0 (except 205.013/047/053/054), 205.3, 213.0 (except 213.016/050/053/054) with code 30P (Stowage Space package) Model 213.0 (except 213.016/050/053/054) with code 30P (Stowage Space package) Bolt, cargo retainers/tie-down eye to body |
*BA68.50-P-1001-03J |
Model 205.0 (except 205.013/047/053/054), 205.3 with code 30P (Stowage Space package) Screw/bolt for tie-down eye |
*BA68.50-P-1001-03I | ||
| 3.2 | Remove expansion rivet at trunk floor front section (4). | Model 205.0 (except 205.013/047/053/054), 205.3, 213.0 (except 213.016/050/053/054) except code 287 (Folding seat backrests in rear passenger compartment) Model 205.1 (except 205.147), 213.1 (except 213.153/155) |
Fig 2 |
| 4 | Unclip trunk floor front section (4) and remove towards rear. | ||
| 5 | Install in the reverse order. |
CARGO RETAINERS
| Number | Designation | Model 205 | |
|---|---|---|---|
| BA68.50-P-1001-03I | Screw/bolt for tie-down eye | Nm | 24 |
CARGO RETAINERS
| Number | Designation | Model 213.0 | |
|---|---|---|---|
| BA68.50-P-1001-03J | Bolt, cargo retainers/tie-down eye to body | Nm | 24 |