Remove/Install Trunk Lid Lock - AR88.50-P-0003LW

Model 205.0/1/3/4 

Model 213.0/1 

Model 238 

Fig 1: Trunk Lid Lock Components Location - Model 205.0/3/4 (Shown On Model 205.0)

Courtesy of MERCEDES-BENZ USA

Shown on Model 205.0 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, Trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on Sensor System For Trunk lid Opening/Closing		AH80.61-P-0001-01A
	Remove/Install
1	Remove panel at Trunk lid (1)	Model 205.0/1	AR68.30-P-8151LW
		Model 205.3	AR68.30-P-8151CLW
		Model 205.4,   Model 238.4	AR68.30-P-8151LWR
		Model 213.0/1, 238.3	AR68.30-P-8151LWE
2	Unhook cable (2) from release (3)	Model 205.0/1, 213.0/1
3	Disconnect electrical connector (4)
4.1	Mark installation position of bolts (5) on Trunk lid (1)	Model 205.0/1, 213.0/1
4.2	Mark installation position of Trunk lid lock (6) on Trunk lid (1)	Model 205.3/4, 238
5	Remove screw/bolts (5)	Installation:  Align Trunk lid lock (6) according to markings. Bolt, Trunk lid lock to Trunk lid	*BA88.50-P-1004-03A
6	Remove Trunk lid lock (6)
7	Install in the reverse order