Remove/Install Roof Frame Trim Piece - AR88.85-P-0001LWR
Model 205.4
except code 288 (Draft Stop For Convertible)
Model 238.4
except code 288 (Draft Stop For Convertible)
Shown on Model 205.4
| Remove | |||
| 1 | Remove A-pillar paneling | AR68.30-P-4050LW | |
| 2 | Unscrew nuts (2) on roof frame trim piece (1) | ||
| 3 | Remove roof frame trim piece (1) | ||
| Install | |||
| 4 | Glue trim piece (3) to new roof frame trim piece (1) | When replacing roof frame trim piece (1). | |
| 5 | Check seals o bolt on roof frame trim piece (1) | When reusing removed roof frame trim piece (1). If damaged: ↓ Replace seals. |
|
| 6 | Position roof frame trim piece (1), center and tighten nuts (2) | Ensure that seal is seated correctly between roof frame trim piece (1) and windshield. |
|
| 7 | Install A-pillar paneling | AR68.30-P-4050LW |