Remove/Install Tailamp Unit On Trunk Lid - AR82.10-P-4927CLW
Model 205.3/4, 238
Shown on model 205.3
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. | AS00.00-Z-0017-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove | |||
| 1 | Remove panel at trunk lid (1) | Model 238.3 | AR68.30-P-8151LWE |
| Model 205.3 | AR68.30-P-8151CLW | ||
| Model 205.4, 238.4 | AR68.30-P-8151LWR | ||
| 2 | Disconnect electrical connection (2) | ||
| 3 | Unscrew nut (3) | ||
| 4 | Remove inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1) | ||
| 5 | Remove bracket (4) outwards from the trunk lid (1) | ||
| Install | |||
| 6 | Position bracket (4) onto inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1) | ||
| 7 | Screw on nut (3) approx. 4 turns | ||
| 8 | Insert inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1) into trunk lid (1) | Otherwise damage may occur. |
|
| 9 | Tighten nut (3) | ||
| 10 | Connect electrical connector (2) | ||
| 11 | Install panel at trunk lid (1) | Model 238.3 | AR68.30-P-8151LWE |
| Model 205.3 | AR68.30-P-8151CLW | ||
| Model 205.4, 238.4 | AR68.30-P-8151LWR |