Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760LW
Model 205
Model 213
Model 238
Model 253
Model 293
Shown on left front door on Model 205.0
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/Install | |||
| 1 | Disconnect ground line from on-board electrical system battery. | Model 205, 213, 253 | AR54.10-P-0003LW |
| Model 238 | AR54.10-P-0003LW0 | ||
| Model 293 | AR54.10-P-0003EQ | ||
| 2.1 | Remove door lining from the front door. | When removing pressure sensor (2) from front door. | |
| Model 205, 213, 253, 293 | AR72.10-P-1000LW | ||
| Model 238 | AR72.10-P-1000LWO | ||
| 2.2 | Remove door lining from the rear door. | Model 205.0/1/2, 253 with code 298 (Rear Side Air Bag With Belt Force Limiter) Model 213 with code 293 (Side Air Bag In Rear Left And Right) When removing pressure sensor (2) from rear door. |
|
| AR72.12-P-1010LW | |||
| 3 | Disconnect electrical connector (1). | ||
| 4 | Lift tab (arrow A), rotate respective pressure sensor (2) counterclockwise through 90° and remove. | ||
| 5 | Install in the reverse order | ||
| Check | |||
| 6 | Check Supplemental Restraint System (SRS) using vehicle diagnosis system. | When replacing the pressure sensor (2). | |
| Model 205, 213, 253 | AD00.00-P-2000-04B | ||
| Model 238 | AD00.00-P-2000-06LW0 | ||
| Model 293 | AD00.00-P-2000-06FR |