LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> C300 4Matic, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electrical System, Equipment & Instruments - 205 Chassis 3 Of 6 >> Testing & Repair >> Remove/Install Battery - AR54.10-P-0005LW

Remove/Install Battery - AR54.10-P-0005LW

Model 205 (except 205.012/047/147/212/247) 

Model 213 

Model 253 

MODIFICATION NOTES

31.03.2021 Sequence of operation steps revised. Operation step 3  
Fig 1: Battery Components Location - Model 205; Shown On Model 213 Except Code B01
G14201274Courtesy of MERCEDES-BENZ USA

Shown on model 213 except code B01 (48V technology) 

G14201275Courtesy of MERCEDES-BENZ USA

Shown on model 205.086 except code U98 (Lithium-ion battery (LISB)) 

DANGER Risk of fire  /risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury  caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning  caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death  due to voltage U >= 30 V AC and U >= 60 V DC. No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. AS54.10-Z-0001-01A 
  General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment   AH00.00-Z-0300-01A
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on battery   AH54.10-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
REMOVINGINSTALLING Remove/install     
1 Print out checklist for transport safety of on-board electrical system battery (G1). Model 205 (except 205.012/047/147/212/247), 213, 253
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
When replacing the on-board electrical system battery (G1).
 
REFER TO FORMS Transport safety checklist for starter battery, form   OF54.10-P-3000-13A
2 Answer questions on checklist regarding transport safety of installed on-board electrical system battery (G1). Model 205 (except 205.012/047/147/212/247), 213, 253
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
When replacing the on-board electrical system battery (G1).
 
3 Confirm change of on-board electrical system battery (G1) using diagnosis system in signal acquisition and actuation module under Actuation menu item. Model 205 (except 205.012/047/147/212/247), 213, 253
except code U98 (LITHIUM-ION STARTER BATTERY (LISB))
When replacing the on-board electrical system battery (G1).
 
REFER TO SELF-DIAGNOSTIC SYSTEMS   IMPORTANT This updates the charging characteristic for the on-board electrical system battery (G1). AD00.00-P-2000-04B
4 Disconnect ground line (2) from on-board electrical system battery (G1).   AR54.10-P-0003LW 
5 Remove retaining clips (8) using a suitable tool and take off cover (9). Model 205.086/087/386/387
except code U98 (LITHIUM-ION STARTER BATTERY (LISB))
 
6 Remove cover (10). Model 205.086/087/386/387
except code U98 (LITHIUM-ION STARTER BATTERY (LISB))
 
7.1 Unscrew screw (3) of holder (4) until on-board electrical system battery (G1) can be removed. On a holder (4) without seat belt.
IMPORTANT Depending on the vehicle, the holder (4) can also be fitted with a nut.
TORQUE SPECIFICATION Screw/bolt/nut, battery bracket/retaining bracket to battery frame
*BA54.10-P-1008-01A 
7.2 Unscrew screw (3) and place holder (4) to one side with seat belt so that it does not obstruct removal of on-board electrical system battery (G1). For a bracket (4) with safety belt.
IMPORTANT Depending on the vehicle, the holder (4) can also be fitted with a nut.
TORQUE SPECIFICATION Screw/bolt/nut, battery bracket/retaining bracket to battery frame
*BA54.10-P-1008-01A 
8.1 Detach vent hose (5) from on-board electrical system battery (G1). Model 205 (except 205.012/047/147/212/247), 213, 253
except code U98 (LITHIUM-ION STARTER BATTERY (LISB))
INSTALLATION NOTES :
Check bleed hose (5) is correctly seated.
Otherwise leaking battery vapor may damage the vehicle.
 
8.2 Release and disconnect electrical connector a on-board electrical system battery (G1). Model 205 (except 205.012/047/147/212/247), 213, 253
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
IMPORTANT The electrical connection is located next to the ground line (2).
 
9 Remove cover (6).    
10 Disconnect positive line (7) from on-board electrical system battery (G1). TORQUE SPECIFICATION Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery *BA54.10-P-1004-01A 
11 Remove on-board electrical system battery (G1).    
12 Install in the reverse order.    
  Concluding tasks     
13 Answer the questions on the removed on-board electrical system battery (G1) based on the transport safety checklist. Model 205 (except 205.012/047/147/212/247), 213, 253
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
When replacing the on-board electrical system battery (G1).
 
BATTERY

Number Designation Model 205 Model 213
BA54.10-P-1004-01A Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery Nm 6 6
BATTERY

Number Designation Model 253
BA54.10-P-1004-01A Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery Nm 6
BATTERY

Number Designation Model 205 Model 213
BA54.10-P-1008-01A Screw/bolt/nut, battery bracket/retaining bracket to battery frame Nm 23 23
BATTERY

Number Designation Model 253
BA54.10-P-1008-01A Screw/bolt/nut, battery bracket/retaining bracket to battery frame Nm 23