Remove/install sensors for Blind Spot Assist - AR54.71-P-0100NKB
MODEL 117, 156, 176, 242, 246 with CODE 234 (Blind Spot Monitoring)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition | ||
| 2 | Lift/jack up vehicle | AR00.60-P-1000AK | |
| 3 | Loosen rear part of the fender liner in the rear wheel arch (at shielding above rear muffler and rear bumper) and press to one side | MODEL 117 with CODE 234 (Blind Spot Monitoring) |
|
| 4 | Loosen retaining clip of the fender liner in the rear wheel arch in the lower area at the rear bumper | MODEL 156 with CODE 234 (Blind Spot Monitoring) |
|
| 5 | Remove cover under rear axle | MODEL 242 with ENGINE 780 with CODE 234 (Blind Spot Monitoring) |
|
| AR61.30-P-1001NKB | |||
| 6 | Unlock left rear intelligent bumper radar sensor (B29/4) or right rear intelligent bumper radar sensor (B29/5) from the bracket (1) (arrow) and remove | Press fender liner in rear wheel arch to one side in order to guarantee access to the left rear bumper radar sensor (B29/4) or right rear bumper intelligent radar sensor (B29/5). |
|
| 7 | Disconnect electrical connector at left rear bumper intelligent radar sensor (B29/4) or at right rear bumper intelligent radar sensor (B29/5) | ||
| 8 | Install in the reverse order |