Check High-Pressure Fuel Lines - AR07.03-P-1010-03MM
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Engine 133, 152.9, 157, 176, 178, 264, 270, 271.8, 274, 276, 278
Engine 260, 282
MODIFICATION NOTES
| 25.10.2017 | "Check thrust piece" added. | Operation step 4 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1028-04A | Assembly cleaner | A 000 986 56 01 |
Do not re-install damaged high-pressure lines (1).
Fuel system leakage and environmental damage may occur otherwise.
- Tighten union nut (1a) and thrust piece (1b) on the high-pressure line (1) to the rear.
- Clean sealing cone (1c) of high-pressure line (1).
- Determine not deformed area of the sealing cone (1c) using a feeler gauge.
The not deformed area arises from the distance from the first measuring point (1M) to the second point (2M).
If non-deformed area is not at least 1 mm.
↓
Replace high-pressure line (1).
- Check diameter of thrust piece (1b).
This must be 10.2 mm before retightening. In the case of deviations in the diameter:
↓
Replace high-pressure line (1).