LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> A220 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Seats, Bunks, Restraint Systems (2 Of 2) -- 118 Chassis) >> Testing & Repair >> Remove/Install Window Airbag - AR91.60-P-0693MFA

Remove/Install Window Airbag - AR91.60-P-0693MFA

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118, 177, 243, 247 

Fig 1: Window Airbag Components Location - Model 118 (Shown On Model 177.0 Left Side)
G16053499Courtesy of MERCEDES-BENZ USA

Shown on model 177.0 on left side of vehicle 

G16053500Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  during testing and repair operations related to pyrotechnical components Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. AS91.00-Z-0008-01A
Notice  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
  Information, assessment and legal requirements when working with, handling and storing pyrotechnical components   AH91.00-Z-0000-10A
REMOVINGINSTALLING Remove/install     
1 Detach ground line of on-board electrical system battery.   AR54.10-P-0003MFA
2 Remove headliner. Model 118.3, 177.1/9 AR68.30-P-4300MFV
    Model 118.6 AR68.30-P-4300MFD
    Model 177.0, 243, 247 AR68.30-P-4300MFA
    IMPORTANT Lower roof lining on required side only far enough to gain access to the fastening points of the window airbag (1).  
3 Insert pliers through openings (arrows A) to press tabs (arrows B) together and then remove retaining clips (4).    
4 Release and disconnect electrical connector (2) from left window airbag squib (R12/22) or right window airbag squib (R12/23). SPECIAL TOOL Removal lever Fig 2
5 Remove bolt (3). NOTES Bolt, window airbag unit to roof frame *BA91.60-P-1005-01Q 
6 Remove window airbag (1) and place on a suitable surface. Handle window airbag (1) carefully. Otherwise, the remaining interior equipment or paint may be damaged.  
7 Install in the reverse order.    
INSPECT Check     
8 Check Supplemental Restraint System (SRS) using vehicle diagnosis system. If the window airbag (1) is replaced.  
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-06MFA
AIRBAG

Number Designation Model 118 Model 177
BA91.60-P-1005-01Q Bolt, window airbag unit to roof frame Nm 6 6
AIRBAG

Number Designation Model 243 Model 247
BA91.60-P-1005-01Q Bolt, window airbag unit to roof frame Nm 6 6
Fig 2: Identifying Removal Lever (203 589 04 33 00)
G07304958Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals