LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2019 >> A220 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Collision - Paintwork -- 118 Chassis) >> Paintwork Body Repair >> Polish Damaged Areas - Ar98.00-P-0009SX

Polish Damaged Areas - Ar98.00-P-0009SX

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 117, 118, 156, 164, 166, 167, 170, 171, 172, 176, 177, 190, 197, 203, 204, 205, 206, 207, 209, 211, 212, 213, 214, 215, 216, 217, 218, 219, 220, 221, 222, 223, 230, 231, 232, 236, 238, 240, 242, 243, 246, 247, 251, 253, 254, 257, 290, 292, 293, 294, 295, 296, 297, 463 

with scratch-resistant clear coat system  

  Polishing    
1 Wash vehicle. Car Wash *BR00.45-Z-1002-04A 
2 Grind damaged area in paint with fine-grained abrasive paper. IMPORTANT The grain size must be at least P2500. A better option would be a grain size between P3000 and P5000.  
3 Place polishing sponge exactly in the center on the polishing pad. IMPORTANT Before the first polishing operation, spray some deionized water onto the polishing sponge.  
4 Apply a little paintwork polish at the polishing area. IMPORTANT Shake paintwork polish well before use.
MB Nano polish		 *BR00.45-Z-1062-04A 
5 Polish the surface to be treated for at least 10 s at the lowest machine speed, approx. 800 rpm (stage 1) using moderate pressure in a cross-coat action over the damaged area. NOTES
Make uniform movements with the polishing machine and comply with the polishing time at a damaged area.
Otherwise visible irregularities occur in the paint surface.
IMPORTANT On larger areas make sure that you always polish-out one partial area (approx. 1/4 m2 ) at a time. As the paintwork polish pulverizes during polishing, a more marked abrasive effect is visible initially. The high gloss is only produced at the end.
Do not exceed a polishing time of 30 s on any single rub-down area.		  
6 Spray on de-ionized water and remove polish residue using a tack rag.    
7 Seal polished surface with gloss preservation. IMPORTANT Shake gloss preservation well before use.  
    Gloss preservation, 500 ml, DB supply specification 7551.10 *BR00.45-Z-1014-04A 
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1002-04A Car Wash A 001 986 41 71 09
BR00.45-Z-1014-04A Gloss preservation, 500 ml, DB supply specification 7551.10 A 000 986 44 74
BR00.45-Z-1062-04A MB Nano polish A 000 986 87 74
scientia non olet · About LEMON Manuals