Complete Automatic Transmission - BA27.10-P-1000-04F
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Transmission 724.0
AUTOMATIC TRANSMISSION COMPLETE
| Number | Designation | Transmission 724.0 | |||
|---|---|---|---|---|---|
| BA27.10-P-1001-04F | Bolt, clutch housing to transmission housing | M6 | Nm | 8 | |
| M8 | Stage 1 | Nm | 10 | ||
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1002-04F | Bolt, cooler module to transmission housing | Nm | 8 | ||
| BA27.10-P-1003-04F | Oil filter cover to cooler module | Nm | 25 | ||
| BA27.10-P-1004-04F | Oil drain screw to transmission housing | Nm | 30 | ||
| BA27.10-P-1005-04F | Bolt, spur gear cover to clutch housing | Nm | 8 | ||
| BA27.10-P-1006-04F | Bolt, spur gear cover to transmission housing | Nm | 8 | ||
| BA27.10-P-1007-04F | Bolt, lift solenoid to transmission housing | Nm | 8 | ||
| BA27.10-P-1008-04F | Nut (left-hand thread), oil pump gear to oil pump | Stage 1 | Nm | 10 | |
| Stage 2 | ∠° | 180 | |||
| BA27.10-P-1009-04F | Nut, hollow shaft rotor to oil pump | Nm | 7 | ||
| BA27.10-P-1010-04F | Bolt, permanent magnet to reset piston | Nm | 5 | ||
| BA27.10-P-1011-04F | Bolt, park detent to transmission housing | Stage 1 | Nm | 20 | |
| Stage 2 | ∠° | 90 | |||
| BA27.10-P-1012-04F | Bolt, bleed valve to transmission housing | Nm | 6 | ||
| BA27.10-P-1013-04F | Screw/bolt, transmission mount to longitudinal member | Nm | 106 | ||
| BA27.10-P-1014-04F | Bolt, transmission mount to transmission | Nm | 106 | ||
| BA27.10-P-1015-04F | Screw/bolt, transmission mount bracket to transmission | Nm | 58 | ||
| BA27.10-P-1016-04F | Screw/bolt, transmission mount bracket to body | Nm | 58 | ||
| BA27.10-P-1017-04F | Bolt, transmission to engine | Nm | 39 | ||
| BA27.10-P-1018-04F | Screw/bolt, power take-off to coupling housing | M8 | Stage 1 | Nm | 20 |
| Stage 2 | ∠° | 45 | |||
| BA27.10-P-1019-04F | Nut, output flange to power take-off | Nm | 265 | ||
| BA27.10-P-1020-04F | Screw/bolt, differential side gear housing to power take-off | M8 | Nm | 34 | |
| BA27.10-P-1021-04F | Screw plug to power take-off housing | M12 | Nm | 35 | |