Remove/Install Heat Shield On Exhaust Gas Turbocharger - AR09.40-P-6045MFC
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Engine 260 in model 118, 177, 247
Shown on model 177 with engine 260 except code M016 (Performance-enhanced engine) up to model year 2022
Shown on model 177 with engine 260 except code M016 (Performance-enhanced engine) up to model year 2022
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Remove/install | |||
| 1 | Remove oxygen sensor upstream of catalytic converter. | AR07.04-P-0086MFC | |
| 2 | Remove the inerting system line in the engine compartment and place to one side. | Engine 260 in model 118, 177, 247 with code 2U8 (Alternative refrigerant) | AR86.10-P-0119MFC |
| 3 | Remove charge air pipe downstream of exhaust gas turbocharger. | Engine 260 in model 118, 177, 247 with code M016 (Uprated engine) | AR09.41-P-1333MFC |
| 4 | Remove engine air intake duct downstream of air filter. | Engine 260 in model 118, 177, 247 up to model year 2022 with code M016 (Uprated engine) | AR09.10-P-8130MFC |
| 5 | Remove screws (2) | *BA09.40-P-1008-02G | |
| 6 | Remove the front heat shield (1) from the retaining clips (3). | ||
| 7 | Unscrew screw (6), and release upper heat shield (4) from retaining clamps (3) and remove. | Engine 260 in model 118, 177, 247 up to model year 2022 |
|
| *BA09.40-P-1008-02G | |||
| 8 | Install in the reverse order. |
TURBOCHARGER
| Number | Designation | Engine 260 | |
|---|---|---|---|
| BA09.40-P-1008-02G | Bolt, heat shield to cylinder head/holder/support | Nm | 10 |