Remove/Install Paneling On A-Pillar - AR68.30-P-4050MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
Shown on model 177.0 with code 810 (Sound system)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Unclip cover (2). | Fig 1 | |
| 3 | Unclip trim from the A-pillar (1) in the top area and pivot slightly at the top toward the inside. | Fig 2 | |
| 4 | Guide trim on the A-pillar (1) toward the top out of the instrument panel until the electrical connectors are accessible. | ||
| 5 | Release and disconnect electrical connector. | Model 118, 177, 243, 247 with code 810 (Premium sound system) Model 118, 177, 243, 247 with code 853 ("Midline" sound system) |
|
| 6 | Remove trim from the A-pillar (1). | ||
| 7 | Remove left A-pillar tweeter (H20/1) and right A-pillar tweeter (H20/2). | Model 118, 177, 243, 247 with code 810 (Premium sound system) Model 118, 177, 243, 247 with code 853 ("Midline" sound system) When installing new trim on the A-pillar (1). |
|
| 8 | Install in the reverse order. |