Remove/Install Active Brake Assist Electric Controller Unit - AR54.21-P-0700MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 247
with code 258 (Collision warning system with active brake application FCW-Stop)
except code 772 (AMG styling - Front spoiler, side skirts)
Fig 1: Active Brake Assist Electric Controller Unit Components Location - Model 118 With Code 258 Except Code 772
| Notice | Notes on preventing damage to electronic components due to a magnetic tool | AH54.00-P-0002-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1.1 | Remove front section of front fender liner. | Model 118, 177, 247 with code 258 (Collision warning system with active brake application FCW-Stop) except code 228 (Additional warm water heating) except code 772 (AMG styling - Front spoiler, side skirts) |
|
| AR88.10-P-1301MFA | |||
| 1.2 | Remove front bumper and place down on suitable mat. | Model 118, 177, 247 with code 228 (Additional warm water heating) with code 258 (Collision warning system with active brake application FCW-Stop) except code 772 (AMG styling - Front spoiler, side skirts) |
|
| AR88.20-P-2000MFA | |||
| 2 | Release and disconnect electrical connector from Active Brake Assist controller unit (A108). | ||
| 3 | Unhook Active Brake Assist controller unit (A108) from retaining tab and remove from bracket (1). | ||
| 4 | Install in the reverse order. | ||
| 5.1 | Commission Active Brake Assist controller unit (A108). | If the Active Brake Assist controller unit (A108) has been replaced. | |
| AD00.00-P-2000-06MFA | |||
| 5.2 | Perform calibration of Active Brake Assist controller unit (A108). | If Active Brake Assist controller unit (A108) is reused. | |
| AD00.00-P-2000-06MFA |