Remove/Install 360° Front Camera - AR54.30-P-3001MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 247
with code 501 (360° camera)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove front bumper. | AR88.20-P-2000MFA | |
| 2 | Release electrical connector (l) and disconnect. | ||
| 3 | Remove mounting frame bow (2). | ||
| 4 | Remove front 360° camera (B84/9). | ||
| 5 | Install in the reverse order. | ||
| Finishing activity | |||
| 6 | Calibrate front 360° camera (B84/9) using vehicle diagnosis system. | ||
| AD00.00-P-2000-06MFA |