Introduction Of 2-Component Epoxy Body Filler Service Information - Si60.00-U-0015A
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model all
A two-component epoxy basic body filler can be ordered via Paragon. Its intended use and properties are below.
Applications
- Repair of surfaced and tinned transitions
- For part replacement when rectifying unevenness
- For part replacement when tinning in seam area
- For part replacement without tinning in seam area (only in combination with adhesive kit A 012 989 17 71)
Properties
- Easy application through static mixer
- Application without primer
- Easy process capability and grinding capability
- Resistant to high pressure, nonshrinking
- Thixotropic set (i.e., the flowability changes to match externally-applied influences)
- Free of solvents, PVC and isocyanates
- Usable up to a maximum coat thickness of 2 mm
- Pot life (processability duration) of 60 to 90 min.
- Both forced hardening (1 h at 60 to 65°C) as well as air dehumidification possible (8 to 24 hours at interior temperature) Generate PTSS case and add attachments to the case.
Ground
- Bright or zinc galvanized steel
- Aluminum
PARTS ORDERING NOTE
| Part no. | Designation | Quantity |
|---|---|---|
| A 012 989 17 71 | Glue kit | 1 |
| A 012 989 29 71 | Two-component epoxy basic body filler | 1 |