Risk Of Fire And Explosion Caused By Machining/Treating Magnesium Components - As60.00-Z-0006-01R

Keep away from ignition sources and open flames. 

Model 171, 172, 211, 215, 219, 230, 450, 451, 452 

Potential risks 

• Risk of fire and explosion caused by machining/treating magnesium components.
• In addition to this, when mechanically processing with coolant lubricants mixed with water, there is also the danger of hydrogen being produced causing an additional risk of explosion (oxyhydrogen gas).
• Magnesium chips or dust mixed with oxygen have a tendency to burn or explode.
• Further information can be seen in the accident prevention regulations or in the specifications of the professional/trade association.

Safety precautions/instructions 

• During machining/treating work do not smoke; stay away from ignition sources and open flames.
• Store and transport magnesium chips only in dry, tightly sealed containers.

  These containers must be stored in a cool place.

Fire protective measures and suitable fire extinguishing agents are: 

• Fire class D extinguishers (with powder nozzle), dry extinguishing blankets or dry sand.

Under no circumstances  : Use fire extinguishers of fire class A, B, C, water, carbon dioxide (CO₂ ) or nitrogen.

First aid measures in the event of burns 

• Following administration of first aid you should always consult a medical service and/or a physician.